Features of aXmFEP

• Mounting on DIN rail, no more than 8 backplanes, for max. 111-modules
• PU25 - 25 Watt power supply 
• CU5200 – central unit featuring LAN interfaces and IEC60870-5-104 protocol 
• CC04 – intelligent communication modules, featuring 4 independent serial interfaces 
• Protocols IEC60870-5-104, IEC60870-5-103, WSR3000, TG065, TG800, and SEAB-1F, further protocols upon request 
• PLC functionality IEC61131-3 
• CAN bus and EtherCAT field bus coupling, also for coupling to intelligent terminals 
• Process image, including complete processing of messages, measured values, counter values, commands and set points 
• Debouncing, flutter suppression, fault/polar difference fault detection, signal voltage detection, message block, normalised measured values, scaled measured values, IEEE measured values, threshold and delta event method, process limits, monitoring, life-zero threshold, zero suppression, operating hours and switching cycle counters, persistent and pulse commands, single and double commands, regulating step command, 1 out of N control in groups, command output time, command selection, command abort, commands with acknowledgement, pushing of commands, normalised setpoints, scaled setpoints, IEEE setpoints
• Time advance and time stamp with an accuracy of 1ms 
• Unified and centralised parameterisation of all decentralised sXmFEP nodes of a telecontrol network via LAN interface

The aXmFEP meets all the requirements on state-of-the-art telecontrol communication. Its compliance with international norms and standards such as IEC60870-5 and IEC61131-3 as well as the automatic configuration of complex telecontrol networks are a special characteristic of the aXmFEP.

Connected to control systems of various manufacturers through the IEC60870-5-104 protocol, the aXmFEP takes over the coupling to different telecontrol protocols and the complete control of drinking and waste water, district heating and gas grids, too. Additional communication security between the stations is ensured by the stand-by transmission route concept as well as the automatic and dynamic configuration of the telecontrol network (“neighbour concept”) and the possibility of using the aXmFEP redundantly.

Technical Data